Metex Shark Multi-Parameter Controllers & Analyzers Bedienungsanleitung PDF herunterladen (Seite 77)

Section 6 - Using the SHARK in Conductivity Mode Page 75

S H A R K

MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL

Section 6 - Using the SHARK in Conductivity Mode

RUN LED (GREEN)

LED WILL BE ILLUMINATED WHEN

SHARK IS IN THE RUN MODE.

WILL BE OFF WHEN SHARK IS IN

THE MENU MODE.

4 DIGIT, 7 SEGMENT LED DISPLAY

DISPLAYS PROCESS VALUE IN RUN MODE.

DISPLAYS CALIBRATION DATA IN

CALIBRATION MODE.

RELAY C (ALARM RELAY)

STATUS LED's (RED)



BOTTOM LED WILL ILLUMINATE

WHEN ALARM RELAY IS

ENERGIZED BECAUSE OF LOW

ALARM CONDITION.

TOP LED WILL ILLUMINATE WHEN

ALARM RELAY IS ENERGIZED

BECAUSE OF HIGH ALARM

BAR GRAPH LED's (GREEN)

LINEAR INDICATOR OF PROCESS

VALUE.

1/4" TURN SCREWS

RELAY A STATUS LED (YELLOW)

LED WILL BE ILLUMINATED WHEN

RELAY A IS ENERGIZED.

REMOVABLE TERMINAL

BLOCK CONNECTORS

"SNAP-ON" CONNECTORS FOR

EASY WIRING OF YOUR

CONDUCTIVITY SENSORS AND

PRIMARY 4-20mA OUTPUT.

(REFER TO SECTIONS 3.5, & 3.12)

SIMPLE THREE-BUTTON INTERFACE

FOR FAST & EASY SETUP

(REFER TO SECTIONS 6.0 TO 6.21)

RELAY B STATUS LED (YELLOW)

LED WILL BE ILLUMINATED WHEN

RELAY B IS ENERGIZED.

UNIT LABEL

LABEL TO INDICATE UNIT OF

MEASURE SHARK IS

CONFIGURED FOR.

AUXILLARY LED's

NOT USED IN CONDUCTIVITY MODE.

CALIBRATION FROM THE

FRONT PANEL



4 PUSH BUTTONS USED TO

CALIBRATE THE SHARK FROM THE

FRONT PANEL.

(REFER TO SECTIONS 6.22)

2 LINE, 16 CHARACTER

LCD DISPLAY



MAIN MENU INTERFACE

SCREEN

TEMPERATURE DISPLAY

WHEN THE 'UP' AND 'DOWN' ARROW

KEYS ARE PRESSED

SIMULTANEOUSLY, THE LED WILL

DISPLAY THE CURRENT PROCESS

TEMPERATURE FOR 5 SECONDS.



THIS FEATURE WILL BE DISABLED IF

THE 'TEMPERATURE COMPENSATION

OVERRIDE' IS TURNED ON IN THE

SETUP MENU.

IN THIS CASE THE LED WILL DISPLAY

---- IN PLACE OF THE

TEMPERATURE.

843

11109

1514

1312

FRONT PANEL

INSIDE PANEL

NOTE

WHEN THE SHARK IS TAKEN INTO

MENU MODE VIA THE INSIDE LCD

SCREEN, THE FRONT 7-SEGMENT LED

WILL DISPLAY

----. THE STATUS &

BAR GRAPH LED's WILL BE TURNED

OFF. THE 4 PUSH BUTTONS ON THE

FRONT WILL NOT RESPOND.

OVERFEED LED (RED)

LED WILL FLASH WHEN THE

OVERFEED TIMER IS ACTIVATED.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare

Metex Shark Multi-Parameter Controllers & Analyzers Bedienungsanleitung Seite 77

Kommentare zu diesen Handbüchern